Anti-Jamming GNSS Receiver with AIM+
An anti-jamming GNSS receiver keeps tracking satellites when radio interference is present. Every Eview receiver, from the HB6 and HB10 to the HB50 and HBEV11, is powered by Septentrio modules with AIM+ built in and on by default, removing narrowband, wideband, chirp and pulsed interference and checking signals for spoofing.
Ask a quote See protected receiversHow AIM+ protects your GNSS receiver
What AIM+ handles and how
| Threat | Typical source | What AIM+ does |
|---|---|---|
| Narrowband (CW) | Single-tone jammers, harmonics from on-board electronics | Detects the tone and notches it out of the band |
| Multi-frequency narrowband | Several tones across one or more GNSS bands | Tracks and removes each tone separately |
| Wideband and chirp | Personal privacy devices (in-car jammers), swept-frequency jammers | Filters the wideband energy so satellites can still be tracked |
| Pulsed | Radar, aviation DME and other pulsed transmitters | Blanks the pulses and keeps the clean part of the signal |
| Spoofing | Fake GNSS signals transmitted locally | Signal-consistency checks on timing, Doppler, geometry, frequencies and constellations |
| Navigation data forgery | Spoofed Galileo navigation messages | Galileo OSNMA authenticates the navigation data (mosaic-X5 and mosaic-G5 products) |
AIM+ is part of every Septentrio receiver and is enabled by default. For the difference between the two threats, read anti-jamming vs anti-spoofing.
Eview receivers with AIM+ anti-jamming
| Product | Best for | Key specs |
|---|---|---|
| HB10 | Drones and robots needing fast output and heading | AsteRx-m3 Pro+, dual antenna, 0.15° heading at 1 m, 100 Hz, <10 ms latency |
| HB59 OEM board | Integration into custom electronics | AsteRx-m3 Pro+, Ethernet, 3 UART, dual-antenna heading, 100 Hz, 4.5–12 V |
| HB6 | Lightweight UAV and robot RTK | mosaic-X5, 100 Hz, 45 g, USB-C, microSD, OSNMA |
| HB6 Pro | Dual-antenna heading in 45 g | mosaic-H, heading 0.15° / pitch or roll 0.25° at 1 m |
| HB50 | Low-power, compact platforms | mosaic-G5 P3, 59 × 44 × 12 mm, 50 g, 0.44 W, OSNMA |
| HBEV11 smart antenna | Base or rover with one cable | mosaic-G5, one M12 cable, Galileo HAS, OSNMA |
| HB62 base | RTK base stations in noisy sites | mosaic-X5, NTRIP, Ethernet, 64 GB logging, IP67, 9–36 V |
All products are quote-based. For a complete datasheet, email sales@gnss-solutions.com. Browse all box receivers and GNSS boards.
Where anti-jamming matters
How to choose and install
Anti-jamming GNSS: frequently asked questions
It is a receiver that detects radio interference in the GNSS bands and removes it so it can keep tracking satellites. Eview receivers do this with Septentrio AIM+, which runs inside the module and handles narrowband, wideband, chirp and pulsed interference without extra hardware.
AIM+ (Advanced Interference Mitigation) is Septentrio’s interference and spoofing protection. It is built into every Septentrio receiver and on by default. It filters jamming, shows real-time spectrum plots and runs signal-consistency checks for spoofing, and on mosaic-X5 and mosaic-G5 it works with Galileo OSNMA.
Jamming drowns GNSS signals in noise, so the receiver loses tracking. Spoofing sends fake signals so the receiver computes a wrong position. AIM+ removes jamming and checks signal consistency, and OSNMA authenticates Galileo navigation data, so the two work as layers.
No. AIM+ works in the receiver, so a standard multi-frequency antenna is used. A good antenna mounted away from on-board noise sources still helps. The EV210 and EV220 suit drones, and the EV288 covers L5, E6 and L-band.
Yes. They connect over UART and output NMEA and SBF, with RTCM v3 corrections in. AIM+ runs in the receiver, so no flight controller settings are needed to use it. The HB6, HB10 and HB52 are common choices for ArduPilot and PX4 drones.
Related reading
Protect your positioning from interference
Tell us your platform, interference environment and output needs, and we will recommend a receiver.
Ask a quote